Materials & Manufacturing Process Selection Case Study - 1

Materials & Manufacturing Process natural selection - Case Study ExampleThe CES Edupack software is normally used to select the most suitable natural for the bracken magnetic dish antenna. Several factors are considered when choosing a material for brake book. These include the specific gravity of the material, caloric conductivity, wear resistance and the materials cost per unit volume. This research work focuses on the design of the brake disc and the entire brake assembly, the most commonly used material in the design and the calculations that are heterogeneous in the brake organisation. This research is supposed to sufficiently inform the King Swan Engineering loaded on the brake disc. The Company may, therefore, use the knowledge derived from this report to improve on the current existing brake disc.The brake disc is a metallic wheel in a brake system against which the brake pad rub. As the pad is pushed against the disc, heat is generated. The disc should there have t he capacity to support the heat due to friction. The function of the disc is to stop the vehicle when it comes into contact with the brake pads. The brake disc is connected to the vehicles tire by means of bolts and nuts. The brake pads are normally pushed against the disc via the brake calipers. The brake discs are commonly made of grey cast irons. The cast iron, however, has some shortcomings such as last specific gravity and high heat conductivity. Application of brake discs is traced back to early 1890s. The disc was depression discovered by a scientist known as Fredrick William. The brake discs have better performance as compared to wheel drums. This is attributed to the fact that brake discs come with ventilation holes through which air circulates to the entire disc. The brake disc is composed of a brake disc bolted to the axle or hub of the wheel hubs and the housing called calipers. The calipers. The calipers are connected to the axle plaster bandage in two parts. Each o f the parts has a piston. In between the piston and the disc, there is a friction pad